Makita DUB362 Manual De Instrucciones página 6

Speed change
1
► 1. Adjusting dial
The maximum air volume can be adjusted just by turning the
adjusting dial. This can be done even while the tool is running.
The dial is marked 1 (lowest) to 6 (highest).
NOTICE:
The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
When working in a high temperature circum-
stance, the tool may be stopped because of the
overheat protection system. In that case let the
tool cool down. Avoid setting to speed 6 (highest)
in high temperature circumstances.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing the long nozzle
2
1
► 1. Long nozzle 2. Triangle marking
To install the long nozzle:
1. Align the small projection of the housing with the
groove of the long nozzle.
2.
The length of the nozzle can be adjusted by changing
the locking position.
Installing the extension nozzle/ flat
nozzle (optional accessory)
The extension nozzle / flat nozzle can be installed on
the tip of the long nozzle in the same way as above.
Installing the shoulder strap
(optional accessory)
2
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy
to work with it.
6 ENGLISH
Slide in the long nozzle, and turn it clockwise until
the triangle markings on the long nozzle and the
housing meet each other.