HON Olson Stacker Serie Instrucciones De Instalación

Illustration 1
Illustration 2
Handle
Bolt sleeve
Hole
Nut
Illustration 3
Angled upright
5
/ " socket
32
flat head bolt
CART
Read all instructions and review illustrations
before installing.
Tools required for assembly:
/ " box end wrench
7
16
Adjustable wrench (optional)
/ " Allen wrench (provided)
5
32
/ " Allen wrench (provided)
3
16
This assembly includes:
(1) Cart
(2-4)
(2)
5
(4) Self locking nut (hardware pack)
(1)
5
(1)
3
(1) Adapter bar (G51 and G53 stack chair only)
Handle Installation:
1. Hold handle in position. Illustration 1 shows typ-
ical cart handle positions (cart appearance may
vary). If handle has two bolts pre-installed, sim-
ply pivot handle upward and hold in position.
2. Refer to Illustration 2. Align hole in handle with
bolt sleeve in cart. Insert
3
/ " socket
16
(from hardware pack) into bolt sleeve and
head bolt
through hole in handle.
3. Refer to Illustration 2. Install nut (from hardware
pack) onto bolt and use the
(from hardware pack) and
to fully tighten nut.
4. Repeat steps 2 and 3 for remaining
head bolts. Fully tighten all nuts.
HON Model G51 and G53 Stack Chair Adapter
Bar Installation (refer to Illustration 3):
Stacked chairs can tip and fall resulting in seri-
ous injury or property damage. Follow the
important safety information below:
Do not use cart to stack HON Models G51 and
G53 Stack Chairs unless adapter bar is fully
installed.
If adapter bar is installed, use cart to stack
only HON Models G51 and G53 Stack Chairs.
Adapter bar
Nut
1. Position. adapter bar across angled uprights of
cart and align holes on adapter bar with holes in
angled uprights.
2. Insert a
pack) through each hole in adapter bar and
through angled uprights.
3. Install a nut (from hardware pack) onto each bolt
and use the
pack) and
each nut.
/ " Socket head bolt (hardware pack)
3
16
/ " Socket flat head bolt (hardware pack)
32
/ " Allen wrench (hardware pack)
32
/ " Allen wrench (hardware pack)
16
/
3
7
WARNING
/ " socket flat head bolt (from hardware
5
32
/ " Allen wrench (from hardware
5
32
/ " box end wrench to fully tighten
7
16
" socket head bolt
16
/ " Allen wrench
3
16
/ " box end wrench
16
/ " socket
3
16
42-5372C
(10/05)