System Messages - Overmax AD-06 Manual Del Usuario

•
The alcohol level result will be presented on the display for 30
seconds. The device will switch off later automatically. You
can also shut it down at any time by pressing the on/off key
(E) and holding for 3 seconds.
RECOMMENDED TIME BETWEEN TESTS
After you finish the first test and before you start another, you are
advised to wait for at least a couple of minutes (5-10 minutes at
best) to prevent accumulation of alcohol remains on the sensor
and keep the proper condition of the sensor.
TEST MEMORY MODE:
To check the total number of breathalyzer tests, please follow
the steps below:
•
When counting, press on/off key (E) to display the total
number of tests done. This number helps you decide when
to perform calibration. For more details, see „Calibration".
•
If you want to reset this counter, long-press the left key (C)
until you can see the zero on the counter.
•
It is advisable to re-calibrate the device once a year or after
300 tests, depending on what happens earlier.
DISPLAYING LAST 50 TESTS:
•
Press the on/off key (E) to display history of tests done (they
will be showed on the screen, marked with serial number „1"
and then with relevant result)
•
Press the right key (D) to display previous results.
•
To leave the test memory mode, press the on/off key (E) again.

SYSTEM MESSAGES

Message Meaning of the message
The device has detected high alcohol level (above
4.00‰ BAC / 0.400%BAC /2.00 mg/L).
Insufficient or uneven breath detected. Retake
the test.
EN