Remove Dust From The Rimage 2000I - Rimage 2000i Guia Del Usuario

Rimage 2000i™ User Guide
Materials
Mandatory, continued
New fan filter
Can of compressed air
Torx T10 screwdriver
New ink cartridges
Optional
None needed
Torx T25 screwdriver
11/32" nut driver
5/32" Allen wrench

Remove Dust from the Rimage 2000i

#
Required tools:
•
Can of compressed air
•
Torx T10 screwdriver
1. Press the recorder buttons to open the recorder trays.
2. Power off the Rimage 2000i.
3. Disconnect the cables from the back of the system.
n
n
Caution:nSome cables in this system are latched.
Equipment damage may occur if cables are not
disconnected appropriately.
•
Power cord
•
USB cable
22
All manuals and user guides at all-guides.com
Task
Replace the fan filter. Refer to the
Replace the Fan Filter
page 24.
Remove dust from the system. Refer
to the Remove Dust from the Rimage
2000i instructions on page 22.
Replace the ink cartridges. Refer to the
Replace the Ink Cartridges
on page 25.
Clean the ink cartridges. Refer to the
Clean the Ink Cartridges
on page 24.
Align the printer. Refer to the
Printer instructions on page 27.
Frequency
Monthly
instructions on
Monthly
As needed
instructions
When print quality problems are
instructions noticed
Align the As needed

Note: The printer is aligned at the
factory.
Back Panel
USB Cable
Power Cord
100763_M