Metra Electronics AXXESS HYBL-05 Instrucciones De Instalación página 3

Connections to be made
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative
speaker output.
Installing the HYBL-05
Installing the HYBL-05
1. With all the connections completed, plug the 16- and 18-pin harnesses
into the HYBL-05.
2. Plug the 24- & 18-pin harness into the vehicle side harness, and plug the
a ftermarket radio harness into the aftermarket radio.
3. Reconnect the negative battery terminal.
4. Turn the ignition on, but do not start the car.
5. Press and hold the volume up button on the steering wheel for 5-seconds,
t his will learn BlueLink.
6. If the vehicle came equipped with factory navigation press and hold the mode
button on the steering wheel for 5-seconds (If vehicle did not come equipped
with factory navigation, skip this step).
HYBL-05
Installing the HYBL-05
Testing and adjusting the HYBL-05
1. Turn the aftermarket radio on.
2. Set potentiometer all the way to the left.
3. Set radio to desired level.
4. Adjust the potentiometer to the right until the radio's audio level is high
and free of distortion.
5. Test BlueLink.
6. Reassemble dash and enjoy your new radio.
Additional 12-pin harness (ASWC-1 harness)
This 12-pin harness is to be used in conjunction with the ASWC-1 (not included).
Please refer to ASWC-1 instructions for programming.
3