Metra Electronics HYBL-02 Instrucciones De Instalación

HYBL-02
Hyundai Veloster SPIDIF/Blue Link
interface 2012-up
• Retains factory Blue link
• Provides navigation outputs
• USB updatable
• Retains fade and balance
• Used with the SPIDIF systems
• Retains factory backup camera
• Retains factory 3.5 mm jack
• High level speaker input
• Prewired ASWC-1 harness included
applIcatIons
HYundaI
Veloster
Interface components
• HYBL-02 Interface • 16-pin harness with stripped leads
•18-pin to 24- & 18-pin connector
tools requIred
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
METRA. The World's best kits.
Installation Instructions for HYBL-02
features
2011-up
™ 1-800-221-0932
Caution: Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
connectIons on tHe Interface
from the 16-pin harness with stripped leads:
• Connect the red wires to the ignition wire of the aftermarket radio.
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the purple wire to the radio's right rear positive speaker output.
• Connect the purple/Black wire to the radio's right rear negative speaker output.
• Connect the Blue/White wire to the radio's amp turn on wire.
• Connect the Brown wire to the mute wire of the aftermarket radio.
If the aftermarket radio does not have a Mute wire, tape up the Brown wire.
• The Blue/pink will not be used in this application.
• The Green/purple wire will not be used in this application.
• The orange/White wire will not be used in this application.
• The light Green wire will not be used in this application.
metraonline.com
(continued on next page)
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION