Electrical Connection - Zanussi ZHC4284 Manual Del Usuario

INSTALLING THE COOKER HOOD
Chimney Stack
The chimney consists of two sections.
The lower chimney measures (with the Hood body and
recirculation grilles) 750 mm and the upper chimney
measures 460 mm. The overall installed measurement
is min. 750 - max 1200 mm.
Fitting the Upper Chimney and
the Hood Body
• Insert the upper duct and fix it on the top of the
upper duct connection using the 12c screws (2.9 x
9.5) supplied with the appliance.
Recirculation version
• It is necessary to make sure that the air outlet con-
nection 15 is placed correctly so that the air outlet
grid in it corresponds to that of the chimney.
• If the grids of the two parts are not corresponding
to each other, it will be necessary to remove the
chimney and to adjust the position of the air outlet
connection 15, and at last to assembly the parts again
by following the earlier indications.
Before fixing the hood body to the frame:
• Open the suction panel by turning the specific
knob.
• Disconnect the panel from the hood canopy by sliding
the fixing pin lever.
• Remove the grease filters from the hood body.
• Remove any activated charcoal filters.
• From below, use the 4 screws 12f (M6 x 10) provided
to fix the hood body to the frame.

Electrical Connection

• Connect the Hood to the mains power supply, inserting
a two-pole cut-out switch with contact aperture of at
least 3 mm along the line.
• Pull the Comfort Panel to open it, ensure that the
supply cable connector is properly inserted into the
Suction device socket
• Join the connectors.
• Install the odour filter and the charcoal filter in case
the hood is to be used in recycling version.
• Install the grease filter again, and successively the
suction panel.
GB
���
���
19