Code Setting - HOMEDEPOT Defiant DF-6026-WH-B Manual Del Usuario

Code Setting

1
Locating the Dip Switches
It is recommended to only change one code position at
a time and then check to see if system is functioning
properly.
On the motion sensor (A), open the battery
cover and remove the batteries to locate the
dip switches.
Unscrew the light socket control (B). Remove
the cover plate on the rear to locate the dip
switches.
A
DAY NIGHT
NIGHT ONLY
1 2 3 4
DETECT
CODES
3
Changing the Code Setting
The motion sensor (A) and light socket control (B) both have four different dip switches. Dip switches 1
through 3 are used for setting the code. Change the
code whenever the light socket control (B) is receiving
interference from another transmitter.
Change the same dip switch setting on both
the motion sensor (A) and the light socket
control (B). Example: Move dip switch 1 to the
"ON" position.
NOTE: Dip switch 4 sets the group (A or B). This dip
switch must match for the two units to communicate.
All manuals and user guides at all-guides.com
2
B
10
Changing the Group Setting
If more than one system of motion sensing controls
is desired, use the 4th dip switch to change the
group setting. This allows multiple systems to work
separately from each other.
Change the 4th dip switch on both the motion
sensor (A) and the light socket control (B) to
change the units to another group setting.
NOTE: The motion sensor (A) and light socket control
(B) must have the same code and group setting to work
together.
Group A
Group B
Motion sensor
Light socket
control