Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION K-2011, K-2013:
Rough-in the supplies and drain piping according to the roughing-in
dimensions illustrated, see Pages 2 and 3.
NOTE: Control stop handle when in full open position must not
extend more than 4" (10.2cm) from finished wall.
Install sufficient backing behind the finished wall for anchoring
devices.
For K-2011: locate the pedestal mounting hole 11-3/16" (28.4cm)
from the finished wall and on the centerline of the lavatory.
NOTE: Do not drill floor anchor hole for pedestal at this time.
For K-2013: locate the pedestal mounting hole 8-1/4" (21cm) from
the finished wall and on the centerline of the lavatory.
NOTE: Do not drill floor anchor hole for pedestal at this time.
For K-2011 or K-2013: apply eight of the self-adhesive gaskets
(provided) on the top edge of the pedestal.
NOTE: These gaskets may need to be repositioned as
necessary to improve fit.
Place pedestal on centerline in approximate location.
Carefully place the lavatory over the pedestal.
Move the pedestal slightly as required to ensure proper fit and
centering in the recess on the bottom of the lavatory.
Check the level of the lavatory.
NOTE: The lavatory must be supported by the pedestal. Make
sure the lavatory is centered.
Mark the centers of the anchoring holes for the lavatory and mark
a line at the front of the pedestal.
Remove the lavatory and pedestal.
Measure from the front of the bottom of the pedestal to the
mounting hole. For K-2011 – use front hole; see "Y". For K-2013 –
use center hole; see "X". Compare this dimension to the distance
between the line on the floor and the location of the mounting hole
previously marked. Relocate mounting hole if required.
Drill holes for 5/16" hanger bolts for securing lavatory and pedestal.
Other fastening devices of sufficient size and strength may also be
used.
Mount the hanger bolts to the wall and floor leaving approximately
1-1/4" (3.2cm) of bolt exposed.
Before installing the lavatory, attach the faucet and drain fittings.
RECOMMENDATION: Attach valve bodies before spout.
Make sure that the 1-1/4" (3.2cm) tailpiece is installed to the drain
body. Attach U portion of P-trap to tailpiece. Refer to faucet and
drain manufacturer's instructions.
NOTE:
Do not fully tighten the slip-joint connection.
A
1007270-2-
FINISHED WALL
11-3/16" (28.4cm)
FINISHED WALL
8-1/4" (21cm)
K-2011
FINISHED WALL
K-2013
8-1/4" (21cm)
X
K-2013
4
Fig. #3
Fig. #4
K-2013
Fig. #5
K-2011
11-3/16" (28.4cm)
PEDESTAL
BASE
Y
K-2011
Fig. #6
Kohler Co., Kohler, WI U.S.A
Tabla de contenido
