endolite Orion3 Guía De Usuario página 7

Battery Charging
Fully charge the battery before first use.
We recommend that the Orion3 knee should be fully
charged every night. It should take up to 8 hours to
charge fully. We also recommend battery charging
whenever convenient. Beware; misalignment while
plugging in may cause damage to the connector.
Step by Step Guide:
1. Lay the knee on a flat surface.
2. Switch the Battery On/Off switch to ON.
3. Connect the charger plug to the charging socket on
the posterior part of the knee module.
4. Check the Battery Charger LED is flashing green to
confirm the battery is charging.
5. Refer to table below to ensure the knee is charging.
6. Disconnect from the charger when charged
sufficiently.
7. Wait for 30 seconds while observing the Orion3 LED
changing color as indicated:
Red
Orion3
LED
8. After a successful reset sequence 2 short beeps will
be heard.
9. If the reset sequence is unsuccessful or the LED
remains Red switch the battery Off then On and
repeat from step 7.
Battery Charger LED
Yellow
Green > fast flashing
Green > slow flashing
Green
Yellow > fast flashing
NOTE:
If the battery charger LED is yellow and the knee
is making a clicking noise check that the Battery
switch is in the ON position.
All manuals and user guides at all-guides.com
(continued)
Blue Red
Charging state
Standby
Fast charging
Close to full charge
Maintain (trickle charge)
Error (Ensure Battery Switch
is ON)
7
Battery
Charger
Battery
Charger
LED
Green Off
LED
The user can enable/
disable the audible reset
confirmation by pressing
and holding the [+] and
[-] buttons simultaneously
for 2 seconds. The change
will be confirmed by 2
short beeps.
938375/3-1117