Setting Up Your Fx1; Code Entry Method; Important - Universal Remote Control TOTAL CONTROL FX-1 Manual De Proprietário

All manuals and user guides at all-guides.com

Setting Up Your FX1

There are two ways you can program your remote:
• The Code Entry Method (page 4)
• The Auto-Search Method (page 7)
The Code Entry Method allows you to set up the FX1 using
brand names. It is fast and easy to program. The Auto-Search
Method scans through all the brands in the remote control,
one at a time. It should be used when the Code entry
method does not work.

Code Entry Method

Find the 3 digit code numbers assigned to your brand from the
lists in the back of this manual. The codes are listed by compo-
nent category (i.e., TV, VCR, DVD, etc.), then by brand name.
For instance, if you would like to locate a code for a Sony
television, first locate the TV category and then look for the
Sony brand.
Once you have located the 3-digit codes for each of the
components that you wish to operate with your FX1, write
them ALL down on a piece of paper. It's important that you
write down all the codes listed for your brand because only
one code is going to work with your component.
Using your old remote, turn on the component you want to
program—for example, to program your TV turn on your TV set.
Press the Component button (in this case the button that says
TV) and the SELECT (SEL) button at the same time. Hold down
both buttons for 3 seconds until the TV Component button light
turns on.
IMPORTANT: You have 20 seconds to
perform the next step while you are
in programming mode. If you do not
press a button within 20 seconds, the
LED light will turn off. The remote
will exit the programming mode
and you will have to start over.
4