Remarks On Telemetric Measurement; Console - Batavus C2 Manual Del Usuario

not so tight that normal breathing is prevented.
If you wear the transmitter and belt over a light
shirt, moisten the shirt slightly at the points where
the electrodes touch the shirt. The transmitter
automatically transmits the heart-rate reading to
the meter up to a distance of about 1 meter. The
heart-rate value is displayed in the meter. Follow
your heart rate during the training.

REMARKS ON TELEMETRIC MEASUREMENT

If the electrode surfaces are not moist, the heart
rate reading will not appear on the display. If the
electrodes are dry, they must be moistened again.
Allow the electrodes to warm up properly to
ensure accurate heart-rate measurement. If there
are several telemetric heart rate measurement
equipments next to each other, the distance
between them should be at least 1,5 m. Similarly,
if there is only one receiver and several transmitters
in use, only one person with a transmitter should
be within transmission range. The transmitter is
switched to an active state only when it is being
used for measurement. Sweat and other moisture
can, however, keep the transmitter in an active state
and waste battery energy. Therefore it is important
to dry the electrodes carefully after use. When
selecting training attire, please note that some
fibers used in clothes (e.g. polyester, polyamide)
create static electricity, which may prevent reliable
heart rate measurement.
Please note that a mobile phone, television and
other electrical appliances form an electro-magnetic
field around them, which will cause problems in
heart rate measurement.
All manuals and user guides at all-guides.com

CONSOLE

BUTTONS
1. ENTER
Selects control panel functions and resets the
training data to zero
2. SET
Sets values
3. +/-
Adjusts the training intensity (Level), training
values and profile selection
4. SELECT
Confirms set values
5. RECOVERY
After finishing your training session, press this
button to start recovery pulse measurement
FUNCTIONS
1. CALENDAR, TIME OF DAY AND ROOM
TEMPERATURE
If you are not training and you have not pressed a
button, the control panel switches into the Sleep
mode after about four minutes. The time of day,
date, day of the week and room temperature are
shown on the display.
2. DISPLAY CHANGE (SCAN)
The display changes every 6 seconds:
•
O W N E R ' S M A N U A L B A T AV U S C 2
G B
7