SNOWJOE SUNJOE iON100V-16ST-CT Manual Del Usuario página 15

NOTE: 250 ft. (76.2 m) replacement trimmer line
(model iON100V-STRS-250) is available for use with the
iON100V-16ST-CT cordless string trimmer. Visit snowjoe.
com to purchase this accessory online. Always use the
recommended nylon cutting line with diameter no more than
0.095 in. (2.4mm). Using line other than that specified may
cause the string trimmer to overheat or become damaged.
1. Press together both release tabs on the line spool cover
and remove the cover by pulling it straight off (Fig. 24).
Fig. 24
2. Lift and remove the spool out of the hub (Fig. 25) and
clean out the remaining cutting line, remove any jams, or
dirt and grass residue.
Fig. 25
3. After cleaning the jam and remaining trimmer line,
reassemble the spool and the spool cover on the motor
head. Make sure to align the marks on the spool, and the
spool cover with the metallic eyelets on the motor head
where trimmer line comes out (Fig. 26).
4. Cut one length of trimmer line 13.2 ft. (4 m) long. Insert the
Spool releasing tab
(on both sides)
Spool cover
Spool
5. Use your left hand to hold the spool cover assembly
Spring
15
Fig. 26
line into the eyelet and push the line until the end of the
line comes out of the opposite eyelet (Fig. 27). Pull the line
from the other side until equal lengths of the line appear
on both sides of the trimmer head.
Fig. 27
Cutting line
Eyelet
steady so it won't move, meanwhile use your right hand to
press down and firmly twist the top of the spool clockwise
as shown. The line will be wound into the trimmer head
(Fig. 28).
Fig. 28
Align the marks
with the eyelet
(on both sides)
Turn the spool top
Spool cover
assembly