Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Production date pressure vessel and pressure vessel lid. Example: 1117
11
Production month, here: November
17
Production year, here: 2017
3.5 Safety Assembly Instructions
•
The terminal device operated with the filter must be free of limescale prior to installation.
Caution: No water softening system may be operated upstream from the filter system.
!
•
Protect the filter system from sunlight and mechanical damage. Do not assemble near sources
of heat and open flames.
•
A stop valve must be installed before the filter system intake hose.
•
If the water pressure is higher than 6.9 bar (100 psi), a pressure reducer must be installed
before the filter system.
•
A non-return valve according to DIN EN 13959 tested by the DVGW has been factory installed
at the water intake of the filter head.
•
No copper pipes, galvanised or nickel-plated pipes/connectors may be installed between the
water filter and the consumer. The use of VIVREAU PURITY hose sets is recommended here.
When choosing the material for parts that come into contact with water after the VIVREAU
PURITY filter system i.e. hoses it must be remembered that, due to the process, decarbonised
water contains free carbon dioxide.
•
All parts must be installed in accordance with the country-specific guidelines on the installation
of drinking water facilities.
4 Installation
Caution: Prior to installation, read the technical data (Chapter 12) and the operating and safety infor-
!
mation (Chapter 3). After storage at below 0°C (32°F) the product must be stored at the ambient tempera-
ture of the installation location in its original packaging (opened) for a least 24 hours prior to commissioning.
4.1 Scope of Delivery
To install an VIVREAU PURITY Quell ST new filter you need packaging units pressure vessel (1)
(incl. filter cartridge) and pressure vessel lid (3).
Prior to installation, remove entire package contents and check that everything is present:
1 x Pressure Vessel
1
1 x Pressure Vessel Lid
1 x Filter Cartridge
2
1 x Manual
1 x temporary hardness test
If parts of the package contents are missing, please contact your local VIVREAU LLC Service
Address.
4.2 Assembling Pressure Vessel and Pressure Vessel Lid
•
•
•
•
•
•
•
•
3
Stand with both feet on the foot rests
Lift pressure vessel
1
over the foot rests
.
12
Remove the transport protective cap
Check O-ring washer of the filter cartridge
and also check for dirt and damage.
Note: The cartridge seat has been greased in the factory with
a foodsafe lubricant.
Stand on the foot rests
Put pressure vessel lid
lock
in relevant groove.
15
Press pressure vessel lid
Put bleed hose
on bleed valve
21
.
12
and turn it clockwise until the mantle handles
from the filter cartridge.
18
2
12
in "INSERT" position on pressure vessel
3
down and turn clockwise until the lock engages.
3
.
9
for correct seat in the groove
1
EN
are
16
with
5
Tabla de contenido
