Switching The Device On - Hama DIT2010MBT Instrucciones Breves

Notes on Use
►
• The [OK] and button on the remote control have
the same function as the [ENTER] button on the front
of the radio.
◄
• The button on the remote control has the same
function as the [BACK] button on the front of the
radio.
▲ ▼
• The buttons on the remote control have the
same function as turning the navigation controller
on the front of the radio to the left and right. (right
controller)
Activating the remote control
Open the battery compartment cover. It is located on the
rear of the remote control and can be opened by sliding it
in the direction indicated. Two AAA batteries are included
in the delivery, they should be inserted in the battery
compartment of the remote control. Observe the correct
polarity when inserting batteries. The polarity (+ / -) is
indicated in the battery compartment.).
Setting up a network connection
4.1 LAN (wired network)
• Connect the LAN connection of your router to the LAN
connection on your radio. You will require an Ethernet
cable, which is not included in the delivery, to do this.
• Make sure that the router is on and working properly, and
that you have an Internet connection.
• See the operating instructions for your router regarding a
properly functioning LAN connection.
• Then proceed as described in point 5, "Getting Started".
4.2 WLAN (wireless network)
• Ensure that the router is switched on, is functioning
correctly and that there is a connection to the internet.
• Activate the WLAN function of your router.
• Follow your router's operating instructions as regards the
correct functioning of the WLAN connection.
• Then proceed directly as described under section 5
‚Getting started'.
4
All manuals and user guides at all-guides.com
5. Getting started
This product is equipped with an antenna connection for
external antennas with coaxial connection. A antenna
that enables DAB, DAB+ and FM reception is included
in the delivery. Alternatively, you can use an active or
passive antenna to improve reception, or according to
your requirements.
Note the following:
• Pull the antenna out completely.
• We recommend you adjust the antenna vertically to

5.1 Switching the device on

• Connect the power cable to a properly installed power
socket.
• Only connect the product to a socket that has been
• Disconnect the product from the power supply using
• Wait until the radio initialisation procedure has finished.
• Press the [POWER] button to switch the radio on.
5.2 Language and setup wizard
The first time the system starts the radio uses English. To
change this, proceed as follows:
Press [MENU] > System settings > Language > Select
language
Confirm your selection by pressing the [ENTER] or [OK]
button.
• You can choose from the following languages:
Note - Optimal reception
ensure optimal reception.
Warning
approved for the device. The electrical socket must
always be easily accessible.
the on/off switch – if this is not available, unplug the
power cord from the socket.
Note
English, German, Danish, Dutch, Finnish, French,
Italian, Norwegian, Polish, Portuguese, Spanish,
Swedish,Turkish, Czech and Slovak.