How To Charge The Battery - flir i3 Manual Del Usuario

EN-US English
Menu system
1. Menu system
2. Measurement result
3. Power indicator
4. Date and time
5. Limit value for the temperature scale
6. Temperature scale
7. Currently set emissivity value or ma-
terial properties
8. Current function for the right selection
button
9. Current function for the left selection
button

How to charge the battery

You must charge the battery inside the
camera for four full hours (or until the
battery indicator displays a green light)
before you use the camera for the first
time.
Charge the battery by connecting the
power supply to the power connector on
the camera. Note: The first time you
charge a factory-new battery you must
turn on and then turn off the camera after
you have connected the power supply to
the power connector on the camera.
20
1. Battery indicator
2. Power supply cable
Quick Start Guide
Follow this procedure to start
immediately:
1. Remove the protective film from the
LCD.
2. Insert a miniSD™ Memory Card into
the card slot.
3. Push the On/Off button to turn on the
camera. Note: If the camera does not
start, push the reset button with a
non-conductive tool. The reset button
is located beside the battery connec-
tor, inside the battery compartment.
Then push the On/Off button again.
4. Open the lens cap by pushing the
lens cap lever.
© 2011, FLIR Systems, Inc. All rights reserved worldwide.
Publ. no. T559526, rev. 001