Uline H-6859 Instrucciones De Montaje página 2

NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that all
parts are included.
IMPORTANT! Turn cam lock 1/4 to the right to
lock.
IMPORTANT! FUNCTION OF CAM LOCK
Ensure the arrow is pointing towards edge of
panel before inserting into the panel's hole.
IMPORTANT! Cam lock pins must be tightened
once inserted into panel.
NOTE: Use a Phillips head screwdriver to tighten
cam locks, cam lock pins and screws.
1. Install one cam lock pin (A) in back panel (1). Insert
one cam lock (B) into corresponding hole in bottom
panel (2). Fit back panel and bottom panel together
and turn cam lock clockwise until it locks.
(See Figure 1)
NOTE: Cam lock caps (J or L) can be applied
once cam locks are tightened for a finished
look.
Figure 1
1
2. Install one cam lock pin (A) in bottom panel (2).
Insert one cam lock (B) into corresponding hole
in skirt panel (3). Fit bottom panel and skirt panel
together and turn cam lock clockwise until it locks.
(See Figure 2)
PAGE 2 OF 12
1/4 RIGHT TURN
FOR LOCKING
2
A
ASSEMBLY
Figure 2
3. Install cam lock pins (A) and dowels (C) in
side panels (4 & 5). Insert cam locks (B) into
corresponding holes in back panel (1), bottom
panel (2), skirt panel (3) and top support beams
(10 & 11). Fit side panels together with back panel,
bottom panel, skirt panel and top support beams
and turn each cam lock clockwise until it locks.
(See Figure 3)
4. Mount floor glides (D) on side panels. Floor glides
can be adjusted to compensate for uneven floors.
(See Figure 3)
Figure 3
B
J
5. Press female component of shelf supports (E) into
corresponding grooves in shelf (7). (See Figure 4)
Figure 4
3
2
10
5
11
2
4
3
C
1
B
7
A
J
B
C
A
B
L
D
A
J
E
1121 IH-6859