ASROCK 890GM Pro3 Manual Del Usuario página 21

TM
sFire
All manuals and user guides at all-guides.com
2.7 2.7 2.7 2.7 2.7 Jumpers Setup Jumpers Setup Jumpers Setup Jumpers Setup Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper Setting
PS2_USB_PW1
(see p.2, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
USB_PW2
(see p.2, No. 34)
Note: To select +5V_DUAL, it requires 2 Amp and higher standby current provided
by power supply. When you select +5V_DUAL, USB devices can wake up
the system under S3 (Suspend to RAM) state.
USB_PW1
(see p.2, No. 10)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 17)
Default
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3
on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right
after you update the BIOS. If you need to clear the CMOS when you just finish
updating the BIOS, you must boot up the system first, and then shut it down
before you do the clear-CMOS action.
ASRock
Short
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB23 wake up events.
Short pin2, pin3 to enable
+5V_DUAL for USB01/45
wake up events.
Short pin2, pin3 to enable
+5VSB (standby) for
USB6_7/8_9/10_11/12_13
wake up events.
Clear CMOS
890GM Pro3 Motherboard
Open
2 1 2 1 2 1 2 1 2 1