Delta 23-710 Manual De Instrucciones página 13

STARTINg AND STOPPINg MACHINE
Make sure that the switch is in the "OFF"
position before plugging cord into outlet. Do not touch
the plug's metal prongs when unplugging or plugging
in the cord.
In the event of a power outage (such as
a breaker or fuse trip), always move the switch to the
"OFF" position until the main power is restored.
The switch (A) Fig. 30, is located on the front of the
grinder base inside a water resistant enclosure. To turn
the machine "ON" push the left hand portion of the
switch. To turn the machine "OFF" push the right hand
portion of the switch.
ADJUSTINg
SPLASH gUARDS
Two adjustable splash guards (A) and (B) Fig. 31, are pro-
vid ed with your sharpening center. The height of the front
splash guard (A) should be adjusted so the top edge of
the guard (A) is slightly below the grinding surface (C) of
the wheel. The rear splash guard should be positioned
high, as shown. To adjust the splash guards, move the
guards manually.
USINg TOOL AND CHISEL HOLDER
ON DRY WHEEL
When sharp en ing chis els, plane irons, etc., that have
deep nicks, the cutting edge of the tool can first be rough
ground on the dry grinding wheel before fine sharpening
is per formed on the wet wheel. To use the tool and chisel
holder on the dry wheel, proceed as follows:
1. Remove the dry wheel tool rest (A) Fig. 32, and eye-
shield (B).
2. Loosen screw (C) Fig. 33, and rotate wheel guard (D)
to the rear, as shown in Fig. 34, and tighten screw
(C).
D
C
Fig. 33
A
A
13
Fig. 30
B
C
A
Fig. 31
B
Fig. 32
D
C
Fig. 34