Daitsu ADD10 Manual De Funcionamiento Y Usuario página 40

Exterior surfaces of the unit
If a condition listed below occurs,please check the following items to help you to save your time and cost.
Condition
The unit does not
operate.
The "Running" lamp
twikles.
The dehumidifying func-
tion does not work.
No air is discharged.
Operation is noisy.
After the above condition has occurred and corresponding step is used but the breakdown can not be removed or other break-
down occurs, please contact the authorized service centers.
38
MAINTENANCE
Cause
Has the power supply cord been disconnected?
Is the "Red" lamp blinking?
(The tankis full or in a wrong position).
Is the temperature of the room above 36ºC or
below 3ºC.
The tube temperature sensor is failure or dis-
connected.
Is the air filter clogged?
Is air intake port or discharge port
obstructed?
Is the air filter clogged?
Has the unit been poorly installed so it is tilted
or unsteady?
Is the air filter clogged?
What to do
Plug the power supply cord into the outlet.
Discard the water in the drainage tank, and
then reposition the tank.
The protection device is actuated and the unit
can not be started in case operation is under
the bad environment (in that case,please do
not use the dehumidifier).
The sensor must be repaired or reassembled by
competent service department.
Clean the air filter as instructed under "Caring
for the dehumidifier".
Remove whatever is obstructing the discharge
port or intake port.
Clean the air filter instructed un "Caring for the
dehumidifier".
Use the unit in a stable,sturdy location. Prompt:
Put a cushion under the unit and help to reduce
operation noise.
Clean the air filter as instructed under "Caring
for the dehumidifier".