Interior Cleaning; Exterior Cleaning - Ventamatic HeTR H1500 Manual Del Usuario

Interior Cleaning:

The most common cause of overheating is deposits of dust or fluff entering the
heater. Interior dust can be removed by following:
1. Remove heater from the mounting bracket. Set heater on table.
2. Remove the six screws located at the front of the guard, then the carefully remove
guard.
3. Wipe interior: Carefully wipe the surface of the interior with a DRY cloth.
4. Close the safety grille: Secure back to the heater by closing screen and re-installing
the screws.
5. Re-installation: Attach the heater back onto the mounting bracket and lock together
to secure.

Exterior Cleaning:

1. Use a clean, soft and lightly moistened (NOT DRIPPING WET) cloth to gently wipe
off the dirt from the surface of the unit.
2. Be sure not to wet the heating element and the switches.
3. Allow the unit to dry completely before using it.
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE HEATER
AS THIS COULD CREATE A FIRE OR ELECTRIC SHOCK HAZARD, DAMAGING THE
UNIT.
1. Perform the cleaning procedures described in "Cleaning/Maintenance".
2. Wipe all parts to dry.
3. Remove the heater from the mounting bracket and tape screws to the unit.
4. Pack the heater in a plastic bag and store it in a cool, dry place.
Ventamatic, Ltd. P.O. Box 728, Mineral Wells, TX 76068-0728
STORAGE
10
1-800-433-1626 Fax: 940.325.9311 www.BVC.com
PLEAS
NOTE:
Do not
the ma
Make s
this op
WHEN
BE FOL
PERSO
1. Rea
2. This
Kee
and
awa
heat
3. Extr
by o
unat
4. Alwa
outl
5. Do n
and
6. Do n
use
dus
7. This
loca
8. Do n
Arra
so th
9. To d
at m
10.Con
11.Con
exte
appl
dam
12.Do n
this
13.To p
use
14.A he
gaso
15.Use
the m
to pr
16.This
else
spe
mal
9