Technical Specifications - PNI GD-01 Manual De Usuario

INTRODUCTION
This product is a detector designed to identify gas leaks.
GAS DETECTOR DESCRIPTION
Main features
- High reliability sensor
- Auto reset after alarm
- Induced gas - natural gas / LPG
- Indoor use, wall mounting

TECHNICAL SPECIFICATIONS

Power voltage
Output voltage for the gas valve
Standby current
Alarme current
Rated power
Warm-up time
Sound level
Alarm level
Alarm gas density level
Operating temperature
Dimensions
INSTALLATION
1. Please confirm the induced gas is heavier than air or lighter than air. Gas heavier than air: LPG etc. Gas lighter
than air: natural gas, marsh gas and etc.
2. Depending on the weight of the gas, choose the correct location of the gas detector. If the gas is heavier than
the air, position the gas detector at 0.3 - 1.0 m up from the floor, over a range of max. 1.5 m of the gas source. If the
gas is lighter than the air, position the gas detector at 0.3 - 1.0 m down from the ceiling, over a range of max. 1.5 m
of the gas source.
3. Fasten the screws firmly into the wall, then hang the gas detector.
4. Avoid installing the gas detector near the following sources: direct air flow caused by wind, ventilators, open
doors or windows, steam sources, oil vapor, etc.
5. The wires must have the correct size and color to avoid damages to the device or shortcircuit. A faulty wire
connection may have repercussions in the event of an alarm due to gas leakage.
230V
9 - 12V (impulse)
≤ 1W
≤ 2.5W
3W (@230V)
about 180 seconds
≥ 70dB/m
20% LEL (Lower Explosive Limit)
0.1% - 0.5%
-26°C ~ +80°C
110 x 73 x 41 mm
3
EN