Fitness Bike Installation Location - Sportana Eagle II Manual De Instrucciones

7. Connect the pull strap (17) to the mounting strap (18).
8. Finally, check whether all screws are firmly tightened.
Insert and replace batteries
(2 x AAA batteries not included)
1. Remove the old batteries if necessary.
2. Insert the new batteries into the battery compartment. Make sure that the polarity is correct.
3. Close the battery compartment.

FITNESS BIKE INSTALLATION LOCATION

Place a suitable, non-slip base (e.g. rubber mat, wooden board or similar) under the device
•
should the set-up location require special protection against pressure points, soiling and
the like.
When using your fitness bike, you must
maintain a minimum radius clearance of 0.6
meters around your workout area. This is
important so that you do not feel confined
during your workout and can get on and off
without obstruction.
equipment are placed next to each other, a
clearance of at least 0.6 meters must be
maintained around both training areas.
24
If two pieces of
www.DEUBAXXL.de