Tabla de contenido
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Replacing the Ribbon
To Remove:
1. Pull the two white release
tabs (B) upward. Remove
the ribbon cassette.
Error Messages
Possible Error Messages:
Home sensor, motor
P r
E E l l
carriage stuck
P r
E E 4 4
Carriage stuck
For error messages E1 through E4, turn off the power before checking to see
that the carriage is not stuck or jammed. Also, check to see that the ribbon
cables are in good condition. After clearing any jams, restore the power and
press the RESET button.
d d L L
The
error message signifies that an attempt was made to get into the
Program mode during the daylight saving changeover one-hour lockout. Wait
one hour and you will be able to program the clock.
To Insert
1. If the print mechanism is
down and a piece of paper
cannot be inserted, press the
RESET button to move the
carriage up. This will make the
ribbon installation easier.
2. Insert a new ribbon between
the ribbon guide (C) and the
printer head (D).
3. Turn the knob on the cassette
clockwise one turn to take up
any slack in the ribbon.
4. Replace the cover.
5. Check the printing quality to
confirm that you have installed
the ribbon properly.
Timing sensor
P r
E E 2 2
_ _
carriage stuck
P r
E E r r
_ _
General print error
Page 15
Home sensor
P r
_ _
E E 3 3
_ _
Daylight saving
d L
_ _
_ _
time program
PIX-10
Tabla de contenido
