Call; Opening - Auta onex Manual De Instrucciones

5
Functioning

CALL

Call to VILLA
To make the call to a Villa from the Panel ONEX KIT we must consider:
1. THE PANEL MUST BE LINKED TO THE INTERNAL MONITOR/S.
2. WE WILL MAKE A SHORT PRESS, WE WILL HEAR A CONFIRMATION TONE, TO MAKE THE CALL TO VILLA.
The call will have a maximum duration of 30 seconds. If a short press is repeated during the call process, the time will start again
for another 30 seconds.
Call to CONCIERGE
To make the call to a concierge we must follow the following procedure:
WE WILL HOLD THE CALL BUTTON FOR 3 MORE SECONDS AFTER HEARING THE CONFIRMATION TONE.
●
In both cases, during a call in progress, we can redirect said call simply by carrying out the corresponding process:
▷ If we have made a call to the Villa and we press the button again for a long time, the system will cancel the call in progress to initiate a
call to the Concierge. In the same way, during a call to the Concierge, if we make a short press, we will cancel the call in progress to
initiate a call to Villa.

OPENING

By INTERNAL MONITOR
We can open the door by pressing the corresponding button on the internal monitor.
By CARD _ KEYFOB
The panel allows RFID access control. To activate the opening, a MiFare card_key fob must be swiped through the designated reader.
By PUSH-BUTTON
The panel allows mechanical opening by a VOLTAGE FREE pushbutton, connected to the "UNLOCK - GS-GND" terminals.
Programming
In order to use the panel ONEX KIT, we have to link it with the Villa or Housing monitor that will manage it. When the link is correctly carried out
on the monitor, an indicative icon will appear, later through the monitor itself, we will be able to access the internal panel settings as well as
the management of card_key fob.
To put the panel in link mode we will carry out the following procedure:
1. WE WILL REMOVE PANEL POWER
By disconnecting the NETWORK cable if we use PoE, or removing positive in case of local power.
2. WE WILL CONNECT THE POWER SUPPLY AGAIN
We will have 3 minutes to complete the process.
3. WE WILL PERFORM A LONG PRESS UNTIL LISTEN 3 SHORT TONES
WE WILL PERFORM A SHORT PRESS, WE WILL HEAR A LONG TONE.
We will go to the corresponding section of the monitor manual and follow the instructions to finish the process.
QR
MONITOR IP ONEX M16 USER GUIDE
Bringing people together
E
N