Altec Lansing iMW725 Guia Del Usuario página 9

How to Connect the Full-featured Remote Battery
The remote battery (included) is installed at the
factory. However, there is a piece of plastic film
inserted between the battery and the remote's
contacts to prevent the battery from draining
during shipping.
1
Pull the plastic film out of the remote.
How to Replace the Full-Featured Remote Battery 1
Pull the battery holder out about
halfway.
The battery holder is located on the
lower end of the back of the remote.
Use a fingernail to pull the latch toward
the centerline of remote while using
another fingernail to simultaneously pull
the battery holder out of the remote.
2
Remove the used battery and replace it with an identical
battery.
3
Push the battery holder back into the remote, making sure the
battery stays in place.
You will hear and feel the latch click.
NOTE Please discard used batteries properly.
All manuals and user guides at all-guides.com
How to Turn On Your Speaker
1
Make sure you have power to the unit.
Ensure the AC adapter is connected to the system and plugged into
the wall, or that the rechargeable battery is fully charged. See the
Getting Started and How to Charge the Lithium-Ion Battery sections
for more information.
2
Turn the unit on.
Press the button on either the speaker or the remote until the
speaker turns on.
How to Turn Off Your Speaker
Turn off the unit.
Press the button on either the speaker or the remote.
NOTE Whenever you are finished listening to your music, please remember
to turn off your speaker and computer or portable audio device to conserve
electricity.
NOTE If you are not going to use your inMotion Air speaker for more than
a few weeks, set the shipping and long-term storage switch to the "OFF"
position and unplug the speaker.
Getting Started
7