Attaching The Fan Blades - Turn of the century Knit Manual Del Propietário

8.
2. Install the remaining two mounting
screws into the holes in the canopy and
tighten firmly.
3. You may now proceed to attaching the
fan blades.
LOCKING SLOTS OF THE CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING. DO
NOT LEAVE THE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE
ENGAGED AND FIRMLY TIGHTENED.
Attaching the
Fan Blades
1. Attach blade to blade bracket using the
screws provided as shown in figure 13.
Please note that the rubber washers are
pre-attached to the blade bracket. Insert
a screw into the bracket. Repeat for the
two remaining screws.
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor
by inserting the alignment post into the
slot on the bottom of the motor and tight-
ening the motor screws. Please note
that the motor screws are pre-attached
into the blade bracket (Figure 14).
4. Repeat steps 1-3 for the remaining
blades.
All manuals and user guides at all-guides.com
PLEASE REMOVE RUBBER MOTOR STOPS
ON THE BOTTOM OF THE FAN BEFORE
INSTALLING BLADES OR TESTING MOTOR.
Light Kit Option
Your fan is supplied with a light kit assembly
and extra plastic plug for non-light option,
allowing you the option of utilizing your fan
with or without the light kit. Once you have
decided which option you will use, proceed
with the corresponding instructions.
Fan with Light Kit
Remember to disconnect the power.
1. Remove the three mounting screws on
the switch cap of the light kit.
2. Connect the wires for the light kit exiting
the bottom of the motor with the wires
from the light kit. See Figure 12.
3. Slide the switch cap up and secure the
switch cap to the switch housing using
Figure 13
the three screws that were removed in
Step 1.
4. Remove the nut and glass shades.
5. Turn the power off, insert the bulbs
(included) into the light kits (Max 60W.
candelabra).
6. Insert the glass shade and secure it with
the nut. The pull chain should come out
from the support bracket.
7. Pull chain for speed selection passes
through the holes of another support
Figure 14
bracket.