Stanley IntelliSensor Plus Manual De Instrucciones página 5

4.0 Calibration
Calibrate the unit on wall before scanning
for wood or metal stud.
IMPORTANT
before calibration is complate and before
g r e e n L E D & D e p t h L E D g o e d o n .
N o t e : W h i l e c a l i b r a t i n g , t h e
IntelliSensor™ Plus must not be placed
directly over a stud, dense material such as
metal, wet or newly painted areas as this
will prevent the unit from calibrating
properly. If this is done over wood or
metalstud the unit will give no indication
when moved away from the area. Move
to a different location and try again.
USAGE
5.0 Calibrating
Following the requirements of 3.0, and 4.0,
hold the IntelliSensorTM Plus flat against
the surface, making firm contact. Select
depth (3.0) and hold the "ON" button. The
sensor will sound an audible "beep" (for 1-3
seconds) while self calibrating (Do not move
while calibrating). The Buzzer will stop
signifying the calibration is finished, (Only
t h e s i n g l e b o t t o m " G r e e n " L E D w i l l
illuminate).
Notes: Releasing the on-botton will turn off
the sensor.
: The unit cannot be moved
5