Getting Started - MAURER 53611 Manual De Uso

6. Getting started

6.1 Inserting the batteries in the receiver
• Place both instruments on a desk with a distance of approximately 1.5 meter. Avoid getting close to
possible interference sources (Electronic devices and radio installations).
• Remove the protective foil from the display of the receiver.
• Remove the battery cover and insert two new batteries 1,5V AAA,polarity as illustrated,Close the battery
compartment again.
• The device will alert you with a beep and all LCD segments will be displayed for a short moment.
• The default:
TIME:2016-1-1, 0:00;
Hour system: 24hr;
• The pressure is blinking,press "C/F/+" or "RCC/-" to adjust the value,press "BARO" to confirm and quit;
if no button pressed,then after 20s it will be auto quit the setting and go to RF search.
6.2 Inserting the batteries in the outdoor transmitter
• Open the screwed battery compartment of the outdoor transmitter.
• The slide switch for channel selection is at position 1 (default).
• Insert two new batteries 1,5 V AAA, polarity as illustrated.
• Close the battery compartment again.
6.2.1 Reception of the outdoor values
• The outdoor values of the outdoor transmitter will be transmitted to the receiver. The displays of the
outdoor values are flashing "--.-".
• On the display of the receiver appear the channel number, the outdoor humidity and the outdoor temp-
erature in °C (default).
• If the reception of the outdoor values fails within three minutes, "- -"appears on the display. Check the
batteries of the transmitter and try it again. Check if there is any source of interference.
• You can also start the outdoor transmitter search manually later on (for example when the outdoor
transmitter is lost or the batteries are changed).
• Hold the CH button on the receiver for three seconds,"---"appears on the display.
• Press the TX button in the battery compartment of the outdoor transmitter.
• The device will alert you with a beep and the receiver receives the values from the outdoor transmitter.
• After successful installation close the battery compartment of the outdoor transmitter carefully.
6.3 Reception of the DCF frequency signal
• After the reception of the outdoor values, the device will now scan the DCF frequency signal and
the DCF symbol will be flashing on the display.
• To avoid interference, the other buttons (except -/RCC) will no function during the reception of the
radio controlled clock.
• When the time code is received successfully after 2-12 minutes, the radio-controlled time and the
DCF symbol are displayed steadily in the display. The other buttons are activated permanently.
• You can start the initialization manually.
• Press and hold the -/RCC button for 3 seconds. The DCF symbol will be flashing.
• Interrupt the reception by pressing the -/RCC button again. The DCF symbol disappears.
• The DCF reception always takes place hourly between 2:00 and 5:00 o'clock in the morning. If the
reception is not successfully received until 5:00 o'clock, the next receive operation is again at 2:00
o'clock in the morning.
There are three different reception symbols:
flashing
just tower
• If the clock cannot detect the DCF-signal (for example due to disturbances, transmitting distance,
etc.),the time can be set manually. The DCF symbol disappears and the clock will then work as a
normal quartz clock.(see: Manual settings).
Week langauge:ENG;
Temperature unit: °C; Pressure:1013 hPa
- reception is active
- RCC function ON
no reception
ALARM: 7:00, OFF ;
stays
no symbol - RCC function OFF
-3-
- reception is very good
time is manually set