Manual Time Setting - Technoline WS 6449 Manual Del Usuario


Once the Channel numbers on weather station and sensor are the same, proceed by opening the battery
cover at the back of your wireless sensor and insert 2 x AAA new alkaline batteries to the battery
compartment. Replace the battery cover.

Your weather station will receive the data signal from the outdoor transmitter in a few seconds.

Place your outdoor transmitter in a dry and shaded area once the weather station receives the data of this
sensor.
Note:

If the weather station is used with 2 or 3 transmitters, press "CH" button shortly to display Channel 1,
Channel 2, Channel 3 or cyclic display.

In cyclic display, the channel will be changed every 25 seconds in overview all channels in a short period of
time
Deleting sensors / clearing channels

Press and hold the "CH" button for 3 seconds to clear the current channel to re-register
Display / Keys Details:
There are six function buttons:
DCF Reception icon
successful.

In normal display mode, press this "-/RCC" button to start/stop time searching (DCF).

The tower icon will show solid when the station has received the DCF signal.

No tower icon displayed. The station was unable to receive a signal at this time.
Reposition the station for better signal reception and wait an overnight.
automatically receive Hours: Daily 1:00,2:00,3:00,4:00,5:00 DCF automatically receive, at any time once
received 3,4,5:00 no longer receive the same day
Only if the unit receives summer time, it will display the "DST" icon.

If there is no signal or too much interference the receiver will only be on for 2 minutes.

If the signal is good it may catch a signal in ABOUT 2-3 minutes.

If the signal is marginal it will try to catch a signal for up to 10 minutes.

Manual Time Setting:


Press and hold the "SET" button for 3 seconds in normal display mode to enter time setting mode.

12Hr or 24Hr will flash. Press the "+" or "-" button to select between the 12-hour or 24-hour time format.
Press the "SET" button to confirm and continue.

The time zone will flash on the display. Press the "+" or "-" button to set the desired time zone( setting
range is 0~ +12,0~ -12). Press the "SET" button to confirm and continue.

The hour will flash. Press the "+" or "-" button to select the hour. Press the "SET" button to confirm and
continue.

The minutes will flash. Press the "+" or "-" button to select the minutes. Press the "SET" button to
confirm and continue.

The year will flash. Press the "+" or "-" button to select the year. Press the "SET" button to confirm and
continue.
with full signal strength will appear on screen if the reception of atomic time is
GB 3