Trevi SB 8380 SW Guia Del Usuario página 13

ENGLISH
Caution:
• Some audio outputs which you connect the Sound Bar (like headphone output) can have its own
volume control: make sure you have set on the source device an adequate level audio output otherwise
the Sound Bar will sound even at maximum volume.
• If the sound played by the Sound Bar be distorted means that the input signal is too strong: lower the
volume of the Sound Bar or paid on a level audio source device output more low.
• In case of connection to a TV by headphone output, it may happen that the sound reproduced by the
Soundbar is low even at maximum volume; in this case try connecting the Soundbar to the audio-scart
output using an adapter (not supplied).
VOLUME ADJUSTMENT AND MUTE FUNCTION
1. Press the + button (9) on the remote control or press and hold the VOl + button (5) on the unit for a few seconds
to increase the volume of the device.
2. Press the - button (18) on the remote control or press and hold the VOL- button (3) on the unit for a few seconds
to decrease the volume.
MUTE function: it is possible to activate the mute function of the device using the MUTE button (14) on the remote
control. To reactivate listening, press the MUTE button (14) again.
USB IN
1. Insert a USB memory into the USB input;
2. Switch on the appliance. The contents of the USB will be automatically played;
3. Press the button (11) on the remote control or the button (4) on the unit to temporarily stop playback. Press it
again to resume playback;
4. Press the (10) or (17) button on the remote control or the (3) or (5) buttons on the unit to skip to the previous or
next track.
5. Press the REPEAT button (19) on the remote control to activate continuous playback of a single track (ONE) or
all tracks (ALL).
AUX IN
1. Use a 3.5mm Stereo jack cable to connect the AUX input on the back of the sound bar to the headphone / audio
output of the TV or other source device;
2. Select the AUX input;
3. For correct sound reproduction, refer to the VOLUME ADJUSTMENT AND MUTE FUNCTION chapter and the manual
of the source device.
OPTICAL INPUT
1. Use a digital optical cable (not included) to connect the OPT input to the digital optical output of the TV or other
source device;
2. Turn on the device and select the OPT input.
Note:
• Before connecting the optical cable, be sure to remove the plug protection cover if your cable is
equipped with it.
• Some TVs or devices is necessary to enable the digital optical output.
• PCM digital audio must be set on the source device for playback from this input.
13
SB 8380 SW