Assembly - LEGEND FORCE LF20212RT Guía De Uso Y Cuidado

Assembly

1
Assembling the Depth Regulator
NOTICE: This tiller is shipped without gasoline or oil in the engine.
Fill up the gasoline and oil BEFORE operating your machine.
□
Insert the depth regulator (C) through the protective
shields (D) opening into the top of the depth regulator
bracket with handle facing to the rear.
□
Insert depth regulator clevis pin (EE) through the depth
regulator bracket. Then insert the cotter pin (FF) to secure.
The top hole of the depth regulator tines should clear
the ground. See Figure 1-1.
C
FF
EE
Figure 1-1
2
Assembling the Protective Shield to
the Tiller Body
□ Locate the plates with the pre-drilled holes on the rear part
of the tiller body. Align the protective shield (D) holes to the
plate holes. Insert M8x20 bolts (AA) with spring washers
(HH) and regular washers (GG) and tighten with a wrench.
See Figure 1-2.
WARNING: Make sure the tiller protective shield is
installed in place before starting the machine.
D
Depth Regulator
Bracket
D
GG
HH
AA
AA
HH
GG
Tiller Body
3
Assembling the Lower Handle
□ The lower handle is attached to the outside of the transmission
cover. Align the lower holes to the desired angle and
insert M10x25 bolts (CC) and M10 Nuts (DD) to secure the handle
on both sides. See Figure 1-3.
NOTICE: There are 3 pre-drilled holes on the transmission cover to
choose from for angle height.
Transmission Cover
9
Please contact 1-877-527-0313 for further assistance.
AA
GG
AA
Figure 1-2
CC
DD
See Figure 1-3.
HOMEDEPOT.COM
HH
HH
GG
Lower
Handle
DD
CC