Assembling The Seat - Bellelli B-FIX Manual De Instrucciones

EN EN
Do not use the seat on electric bicycles. The seat may be used on Pedelecs.
Check that the limbs and clothes of the child or that of the driver cannot be caught in the moving
parts of the bicycle or in the seat (e.g. in the brakes or the spokes of the wheel). Use a saddle cover
or a saddle with internal springs. Check this regularly with the child's growth.
Check that the child cannot stick fingers nor feet in the wheel spokes.
Check that the child cannot reach any sharp or pointed parts (e.g. frayed brake cables)
Check that the child is dressed sufficiently and warmer than the driver is and appropriately protected
in the case of rain.
Have children wear a safety-approved helmet of an appropriate size (in some countries wearing a
helmet is a requirement, consult the highway code of the country where you use the seat).
Never carry two children at the same time.
The cyclist must be at least 16 years old.
Attach all the straps, even if you are not carrying a child.
Check that the straps cannot reach the wheels or other moving parts of the bicycle, both with and
without the kid on the bicycle.
Always check before placing the child in the seat, that the seat is not too hot (this can happen, for
example, when the seat has been exposed to direct sunlight).
Take the seat off the bike when transporting it on the outside of a vehicle (e.g. on the roof of a car, on
a trailer or on the back of the RV). The air flow could damage the seat or break the fasteners of the
seat on the bike thus causing an accident.
WARNING: The manoeuvrability of the handlebars can be hindered by the child seat. Replace the
handlebars, if the child seat reduces the steering angle on each side to below 45 °.

ASSEMBLING THE SEAT

WARNING: Do not perform installation operations with the child in the seat.
Normally, the bracket (13) is not necessary for mounting the support to fasten the bicycle front seat.
Nevertheless, it is recommended to keep the bracket in order to mount the support of the Bellelli seat
at a later date. For this type of installation follow the manual that comes with the rear seat.
Remove the luggage carrier or the basket of a bicycle they obstruct the installation of the seat.
Mounting Support Installation
Locate the area where the mounting support is attached to the bicycle.
See figures C1, C2, C3, C4, C5 and familiarize yourself with the components which are necessary
for mounting the support (fig. A).
Insert the gaskets (4) into the two iron screws (2 or 3). The choice of the correct pair of screws, as
well as the appropriate components, depends on the bicycle frame, as shown in figures C1, C2, C3,
C4, C5. Keep the other pair of screws and the unused components for possible later configuration of
the attachment. Do not confuse the screws of the two pairs.
The screws can be fixed according to four different combinations (fig. B). Select the suitable combi-
nation for the bicycle frame on which the support is mounted.
The configurations shown in figures C1, C2, C3 are equivalent. The right choice of this only depends
on the shape and the dimensions of the bike frame.
REMARK: Correct installation foresees that the nuts completely wrap the screw thread after their
fastening, i.e. There must be no space inside the nut. If this is not the case, the mounting support is
15