Tabla de contenido
Idiomas disponibles
Idiomas disponibles
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for compliance could void
user's authority to operate the equipment.
SAFETY GUIDELINES /
DEFINITIONS
DANGER:
Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
CAUTION:
Used without the safety alert symbol indicates potentially
hazardous situation which, if not avoided, may result in property damage.
RISK OF UNSAFE OPERATION.
safety precautions should always be followed to reduce the risk of personal
injury. Improper operation, maintenance or modification of tools or equipment
could result in serious injury and property damage. There are certain
applications for which tools and equipment are designed. Manufacturer
strongly recommends that this product NOT be modified and/or used for any
application other than for which it was designed. Read and understand all
warnings and operating instructions before using any tool or equipment.
READ ALL INSTRUCTIONS
WARNING:
Read all instructions before operating power station. Failure
to follow all instructions listed below may result in electric shock, fire and/
or serious injury.
IMPORTANT SAFETY
INSTRUCTIONS
GENERAL SAFETY WARNINGS AND INSTRUCTIONS
• This unit was designed for household use only.
WARNING –
RISK OF FIRE, ELECTRIC SHOCK, BURST HAZARD, OR
INJURY TO PERSONS OR PROPERTY
• Avoid dangerous environments. Don't use appliances in damp or wet
locations. Don't use appliances in the rain.
• Keep children away. All visitors should be kept at a distance from work
area.
• Dress properly. Do not wear loose clothing or jewelry. They can be caught
in moving parts. Rubber gloves and substantial, non-skid footwear are
recommended when working outdoors. Wear protective hair covering to
contain long hair.
• Store idle appliance indoors. When not in use, appliances should be stored
indoors in dry, and high or locked-up place – out of reach of children.
• Don't abuse cord. Never carry appliance by cord or yank it to disconnect
from receptacle. Keep cord from heat, oil, and sharp edges.
• Disconnect appliances. Disconnect the appliance from the power supply
when not in use, before servicing, and when changing accessories.
• Ground Fault Circuit Interrupter (GFCI) protection should be provided on the
circuits or outlets to be used. Receptacles are available having built in GFCI
protection and may be used for this measure of safety.
When using tools or equipment, basic
• Use of accessories and attachments. The use of any accessory or
attachment not recommended for use with this appliance could be
hazardous. Refer to the accessory section of this manual for further details.
• Stay alert. Use common sense. Do not operate this equipment when you are
tired or impaired.
• Check for damaged parts. Any part that is damaged should be replaced
by the manufacturer before further use. Do not use tool if switch does not
turn it on and off. Contact the manufacturer at (877) 571-2391 for more
information.
• Do not operate this appliance near flammable liquids or in gaseous or
explosive atmospheres. Motors in these tools normally spark, and the
sparks might ignite fumes.
• Never submerge this unit in water; do not expose it to rain, snow or use
when wet.
• To reduce risk of electric shock, disconnect the unit from any power source
before attempting maintenance or cleaning. Turning off controls without
disconnecting will not reduce this risk.
• This equipment employs parts (switches, relays, etc.) that produce arcs
or sparks. Therefore, if used in a garage or enclosed area, the unit MUST be
placed not less than 18 inches above the floor.
• Do not use this unit to operate appliances that need more than 5 amps to
operate from the 12 volt DC accessory outlet.
• Do not insert foreign objects into the USB port, the 12 volt DC accessory
outlet or the 120 volt AC outlet.
SPECIFIC SAFETY INSTRUCTIONS FOR CHARGING
THIS UNIT
• IMPORTANT: This unit is delivered in a partially charged state. Fully charge
unit with a household extension cord for a full 40 hours before using for the
first time. You cannot overcharge the unit using the AC charging method.
• To recharge this unit, use only the built-in AC charger.
• All Power switches should be in the OFF position when the unit is charging
or not in use. Make sure all switches are in the OFF position before
connection to a power source or load.
EXTENSION CORDS:
WARNING:
Use of improper extension cord could result in a risk of
fire and electric shock. When using an extension cord, make sure that the
pins of the extension cord are the same number, size and shape as those
in the charger; and be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. The following table shows the
correct size to use depending on cord length and nameplate. ampere rating.
If in doubt, use the next heavier gauge. The smaller the gauge number, the
heavier the cord.
MINIMUM GAUGE FOR CORD SETS
Volts
120V
0-25
(0-7.6m)
240V
0-50
(0-15.2m)
Ampere Rating
More
Not more
Than
Than
0 -
6
6 -
10
10 -
12
12 -
16
When an extension cord is used, make sure that:
a) the pins of extension cord are the same number, size and shape as
those in the charger,
b) the extension cord is properly wired and in good electrical condition,
c) the wire size is large enough for the AC rating of the charger.
CAUTION –
TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
Pull the extension cord by the plug rather than the cord when disconnecting
from the built-in 120 volt AC charger or the AC outlet.
SPECIFIC SAFETY INSTRUCTIONS FOR JUMP
STARTERS
WARNING:
BURST HAZARD
Do not use the unit for charging dry-cell batteries that are commonly used
with home appliances. These batteries may burst and cause injury to persons
and damage property. Use the unit for charging/boosting a lead-acid battery
5
Total Length of Cord in Feet
26-50
51-100
(7.6-15.2m)
(15.2-30.4m) (30.4-45.7m)
51-100
101-200
(15.2-30.4m) (30.4-60.9m) (60.9-91.4m)
Extension Cord Length
0'-25'
26'-50'
51 '-100 ' 101' -150 '
American Wire Gauge (AWG)
18
16
16
18
16
14
16
16
14
14
12
Not Recommended
101-150
201-300
14
12
12
Tabla de contenido
