Tabla de contenido
All manuals and user guides at all-guides.com
2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATA3_1: see p.2, No. 12)
(SATA3_2: see p.2, No. 10)
(SATA3_3: see p.2, No. 11)
(SATA3_4: see p.2, No. 9)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 19)
(9-pin USB8_9)
USB_PWR
(see p.2 No. 18)
1
USB_PWR
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 17)
Front Panel Audio Header
GND
(9-pin HD_AUDIO1)
(see p.2 No. 20)
1
MIC2_L
ASRock E350M1/USB3 Motherboard
These four Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
Besides four default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
P-9
P+9
GND
DUMMY
GND
P+8
P-8
This header can be used to
connect the remote controller
1
GND
IRTX
receiver. Please refer to p. 144
IRRX
ATX+5VSB
for details.
This is an interface for front
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
17
Capítulos
Tabla de contenido
