Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Removing or installing saw blade
2
011330
CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
To remove the blade, press the shaft lock fully so that
the blade cannot revolve and use the wrench to loosen
the hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
3
2
1
011331
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
1
2
3
011386
NOTE:
If a inner flange is removed by chance, install the
•
inner flange so that its protrusion (bigger side)
faces inside as shown in the figure.
When changing blade, make sure to also clean the
upper and lower blade guards of accumulated sawdust
as discussed in the Maintenance section. Such efforts
do not replace the need to check lower guard operation
before each use.
1. Shaft lock
1
2. Hex wrench
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
4
1. Hex bolt
5
2. Protrusion
3. Outer flange
4. Saw blade
5. Inner flange
6. Protrusion
6
(bigger side)
4
Hex wrench storage
011332
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Connecting a vacuum cleaner
2
011335
011359
9
1. Hex wrench
1
1. Dust nozzle
(optional
1
accessory)
2. Screw
Tabla de contenido
