Tabla de contenido
T EC HN I C A L I N FO RMATIO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate - 16562xx1, 16563xx1
handshower
spout
Flow rate - 16547xx1, 16553xx1
handshower
spout
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTALL ATI ON CO N SIDE R ATION S
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ This trim is for use with rough 16549181 (not
included).
⁄ This unit is not anti-scald. In Massachusetts, or if re-
quired by local plumbing code, install an approved
remote pressure balance valve or other approved
anti-scald device.
⁄ Protection against backflow is provided by a double
check valve.
This unit meets or exceeds the following:
• ASME A112.18.1/ CSA B125.1
• Listed by IAPMO for use in the US
and Canada
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
max. 1.8 GPM (6.8 L/min)
4.75 GPM (18 L/min) @ 44 PSI
max. 2.0 GPM (7.6 L/min)
4.75 GPM (18 L/min) @ 44 PSI
E N G L I S H
⁄ 16562xx1, 16563xx1 only: This handshower is for
use with automatic compensating valves rated at 1.4
GPM (5.3 L/min) or less.
⁄ 16547xx1, 16553xx1 only: This handshower is for
use with automatic compensating valves rated at
1.5 GPM (5.7 L/min.) or less.
⁄ To prevent scald injury, the maximum output tempera-
ture of the shower mixing valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112° F.
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Tabla de contenido
