Dsp Overview - Phonic JUBI 12A DSP Manual De Usuario

DSP OVERVIEW

Each channel has its own set of options available through
the DSP. These are all visible through the LCD display
and controlled by the DSP MENU control. For a full list of
available functions, check the DSP PARAMETERS chart.
Push the DSP MENU control to select the option you wish
to adjust, turn the control left or right to adjust the param-
eter, and push again to confirm. Push and hold the DSP
MENU control to return to the main menu.
ON/OFF
This option can turn the corresponding channel ON and
OFF. This can be found on all input and output channels.
On the BTin function, this will also activate Bluetooth.
VOLUME
The volume of the currently selected channel (CH1, CH2,
BT in, AUX in, MIX out, AMP out) can be adjusted here. The
volume can be adjusted anywhere between -50 and +6 dB.
HPF (High Pass Filter)
Activating a high pass filter on channels 1 and 2 will help
to remove stage rumble and other low-frequency back-
ground noise often picked up by microphones. The HPF
features an on/off option. Directly below this is a frequency
option where the high pass filter's cut-off frequency can
be adjusted between 50 and 250Hz. This feature is not
available on the Bluetooth or AUX channels.
BASS
Adjust low-frequency audio for any of the input channels
(CH1, CH2, BT and AUX) using the BASS control. The
level of bass can be adjusted between -12 and +12 dB.
The bass control provides a shelving curve for the low-
frequency audio below 250 Hz.
MID LEVEL
The level of the Jubi DSP's mid EQ allows for anywhere
between -12 and +12dB of cut or boost to be applied to
the signal. The mid EQ is only found on the CH1 and CH2
inputs.
MID FREQUENCY
Unlike the treble and bass controls, the mid frequency
control offers a bell-curve for equalization. The Jubi
DSP's mid EQ center-frequency can be adjusted by the
user. This option allows the center-frequency to be ad-
justed between 0.5 and 5 kHz.
TREBLE
The treble of each input channel (CH1, CH2, BT in, AUX
in) can be adjusted through this option. The Jubi DSP al-
lows for anywhere between -12 and +12 dB of cut/boost
to be applied to high-frequency signals. This treble control
offers shelving boost/cut for signals over 2.5kHz.
EFXsend
Adjust the level of the EFXsend to send the corresponding
channel (CH1, CH2, BT in or AUX in) to the internal
REVERB processor. The EFXsend on each channel can
be adjusted between -50 and 0 dB. Turning the control
past the -50dB will turn the EFXsend off.
JUBI 12A DSP / JUBI 15A DSP 3