Installing The Printer - Epson OT-BX88VII Manual De Instalación

Installing the Printer

Follow the steps described below to install the printer on the PS-Cover.
1. Turn off the printer and all the devices connected to the printer, and then
disconnect all the cables connected to the printer.
2.
Turn over the printer.
3. Attach the connector cover (6 in illustration G) to the printer.
Note:
To detach the connector cover with the PS-Cover installed, pull the connector cover
toward the back while pushing both sides of the cover inward.
4. Place the printer and the PS-Cover side by side, and connect the DC cable to the
power connector (5 in illustration G) of the printer. (See illustration G.)
5. Connect other cables, and pass them out through the cable exits of the connector
cover. The connector cover has a cable exit on the back and also on both sides
respectively.
6. Turn over the PS-Cover, and mount it on the printer while setting the DC cable
inside the connector cover.
CAUTION:
When turning over the printer, make sure the DC cable set in the PS-Cover is not
loosened.
Make sure the cables are not pinched between the printer and the PS-Cover.
7. Insert the 4 provided screws in the screw holes, and tighten the screws. (See
illustration I.)
8. Connect the AC cable to the connector of the power unit.
9. Turn over the printer. (See illustration J.)
OT-BX88VII Installation Manual 3
English