Care And Maintenance; Switching The Appliance Off; Cleaning The Appliance; Replacing The Oven Light Bulb - Hotpoint CP87SEA/HA Manual De Instrucciones

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity
supply before carrying out any work on it.

Cleaning the appliance

! Never use steam cleaners or pressure cleaners on
the appliance.
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge which has been soaked in lukewarm
water and neutral soap. Use specialised products
for the removal of stubborn stains. After cleaning,
rinse well and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The hob grids, burner caps, flame spreader rings
and burners may be removed to make cleaning
easier; wash them in hot water and non-abrasive
detergent, making sure all burnt-on residue is
removed before drying them thoroughly.
• Clean the terminal part of the flame failure safety
devices* frequently.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
*
Only available in certain models.
All manuals and user guides at all-guides.com
Inspecting the oven seals
Check the door seals around the oven regularly.
If the seals are damaged, please contact your
nearest Authorised After-sales Service Centre.
We recommend that the oven is not used until the
seals have been replaced.

Replacing the oven light bulb

similar one: voltage 230 V, wattage 25 W, cap E 14.
3. Replace the lid and reconnect the oven to the
electricity supply.

Gas tap maintenance

Over time, the valves may become jammed or
difficult to turn. If this occurs, the valve must be
replaced.
! This procedure must be performed by a
qualified technician who has been authorised by qualified technician who has been authorised by
qualified technician who has been authorised by qualified technician who has been authorised by qualified technician who has been authorised by
the manufacturer. the manufacturer. the manufacturer. the manufacturer. the manufacturer.
This procedure must be performed by a This procedure must be performed by a This procedure must be performed by a
This procedure must be performed by a
GB
1. After
disconnecting the
oven from the
electricity mains,
remove the glass
lid covering the
lamp socket ( see
figure ).
2. Unscrew the
light bulb and
replace it with a
29