Configuring The Wi-Fi Parameters; Mounting The Surveillance Camera - Visidom IC100 Manual De Instalación

IC100
C w -F
onFiguring the i
To complete the installation of your camera for use with the Wi-Fi:
a. Click the icon, then
b. Select the "Advanced" button to open the advanced configuration menu and enter the default
administrator password 123456.
c. In the "Wi-Fi parameters" section, select your Wi-Fi network and enter the passphrase for your
hub. (Fig. 9)
The camera
(for example: !@#$%,). If necessary, the passphrase for your hub will have to be changed.
d. Save the parameters.
e. If you have connected the camera with an Ethernet cable, disconnect the cable.
f. The camera will disconnect for approximately 40 seconds before resetting. The green LINK
light stays on when the camera is connected to the Wi-Fi network. (Fig. 10)
g. Update the camera status to be able to view its image.
If the Wi-Fi connection fails, you can reconfigure the camera by pressing the RESET button for 5
seconds using a pointed tool (Fig. 11). The PWR light flashes then comes on steady. After 40 seconds,
the green LINK light gives three short flashes then one long one. You can then repeat the parameter
setting, see page 6.

MOUNTING THE SURVEILLANCE CAMERA

C
hoosing the loCation
The camera can be placed on an item of furniture, or mounted on a wall or ceiling using its built-in
wall bracket.
You must not direct your surveillance camera towards public thoroughfares or neighbours:
the surveillance camera must not be used to film public thoroughfares or other locations
which are the property of others. It is your responsibility to check the camera's orientation
to ensure these situations do not occur.
w - -
all or Ceiling mounting
a. Fit the screws and their plugs into the wall or ceiling, 30 mm apart. Do not tighten the screws
fully; approximately 1 mm must be left behind the head for the camera base to be attached.
b. Position the holes in the mounting plate built into the camera base on top of the screw heads.
c. Push the camera base flat against the wall (or ceiling), then fit the screw heads into the
notches in the mounting plate.
d. Screw the camera onto its base.
e. Undo the tilt head ring, then adjust the viewing angle.
f. Orient the camera so that the image taken is vertical.
g. Tighten the locking rings when the camera is in the correct position.
8
All manuals and user guides at all-guides.com
i parameters
.
cannot accept passphrases
(F . 12)
ig
(F . 13)
ig
which include special
Copyright © 2015 Somfy SAS. All rights reserved.
characters