Dryer Care; Cleaning The Dryer Location; Cleaning The Lint Screen; Cleaning The Dryer Interior - Maytag PAV2300AGW Manual De Uso Y Cuidado

To use the drying rack
1. Place drying rack in dryer.
Style 1: Your drying rack has front legs. Slide rear pegs into the dimples on the back wall
of the dryer. Lower the front legs to rest on the dryer opening.
Style 2: Your drying rack does not have front legs. Do not remove the lint screen. Slide
drying rack over the bottom of the dryer door opening. Push down to secure drying rack
on frame.
2. Put wet items on top of drying rack, leaving space between items. Do not allow items to
hang over the edge of the drying rack. Close the door.

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.

Cleaning the Lint Screen

Clean lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
16
All manuals and user guides at all-guides.com
3. Select a timed drying cycle and temperature, or an air cycle. Items containing foam,
rubber, or plastic must be dried on a clothesline or by using an air cycle. Refer to the
following table.
4. Start the dryer. Reset cycle to complete drying, if needed.
Rack Dry
Washable wool items (block to shape, lay flat on
drying rack)
Stuffed toys/pillows (cotton or polyester filled)
Stuffed toys/pillows (foam rubber filled)

DRYER CARE

Every Load Cleaning
1. The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off
the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard
to remove.
2. Push the lint screen firmly back into place.
As Needed Cleaning
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to
remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Replace screen in dryer.
1. Apply a liquid, nonflammable household cleaner to the stained area of the drum and rub
with a soft cloth until stain is removed.
2. Wipe drum thoroughly with a damp cloth.
Cycle
Timed
Drying
Timed
Drying
Air
(no heat)

Cleaning the Dryer Interior

Temp Time
Low 60 min.
Low 60 min.
N/A 90 min.