Operating The Unit - BE 4.75HP Manual De Operación

OPERATING THE UNIT

OPERATION PROCEDURES FOR ALL UNITS
i
Be sure to follow the appropriate Start-Up procedure for your pressure
washer before following the below Operation steps.
1
Grasping the gun and
lance with Both Hands,
hold spray nozzle 8-
24 inches away from
cleaning surface.
i
NOZZLE USAGE (5, 6.5, 13HP UNITS)
Be sure to choose the correct Nozzle for the job you are performing.
Below are some examples of when to use each.
O
0
Thin and powerful
stream of water. Used
for difficult to remove
stains.
O
40
Largest angle of spray
used for cleaning sur-
faces quickly.
VARIABLE NOZZLE ADJUSTMENTS (4.75HP UNITS)
i
Spray Pattern
Left: Shrink
Right: Widen
WARNING
Do not allow unit to run for more than 2 minutes without pulling the trig-
ger. Letting the unit idle for too long can cause the pump to burn out. If
it is necessary to stop your work for more than 2 minutes, turn off the
engine (see Shut Down procedures).
8
FOR SERVICE: 1-866-850-6662 & WWW.BEPRESSURE.COM
All manuals and user guides at all-guides.com
Left Right
2
Pull trigger to spray
water.
O
15
Uses a small angle
of spray for focused
cleaning.
SOAPER
Soaper nozzle is used
in conjunction with a
cleaning fluid. This is
the only nozzle that
can be used with
cleaning solution. (On
5,6.5, & 13 HP Models)
Pressure
Out: Decrease
In: Increase
Out In