RISCO Group WL S42 Instrucciones De Instalación Y Programación página 6

Step 2: Setting the Sounder Parameters
Each sounder can be defined with different sets of parameters. The following
table describes the list of parameters of the sounder.
NOTE:
For the specific programming location of each parameter refer to the
system manuals.
Adjusting the Volume
Defines the sounder sound volume for the following system modes.
 Exit / Entry: The sound produced during Exit/Entry time (Default: 0)
 Alarm: The sound produced during alarm (Default: 9)
 Squawk: The sound produced during squawk sounds (Default: 9)
The sound volume range is between 0 (silent) to 5 (maximum volume).
Muting Tamper
This feature disables a tamper alarm from the sounder and it is
recommended to be used when replacing sounder's batteries.
NOTES:
1. An ongoing tamper alarm will not be disabled.
2. WisDom: This feature is controlled under the Engineer Menu
(Quick key [9][2][5]). Tamper alarm will be disabled during the
current installation programming period.
3. Agility: Grandmaster Code/User Menu > Activities > Advanced
> Service Mode (Agility 3 only. The tamper alarm will be
disabled for the time programmed in the Mode Service timer.
4. LightSYS (V2.40 and above): Grandmaster Code/User Menu >
Activities > Advanced > Service Mode. The tamper alarm will be
disabled for the time programmed in the Mode Service timer.
Setting Supervision Time
Specifies how often the system generates a supervision request to the sounder.
If any of the sounders does not respond to the request at least once, during
the receiver supervision time, the system will regard the accessory as lost.
NOTE:
The receiver supervision time should be higher than the sounder
supervision time in order to eliminate false lost event.

Range: 00-255 minutes

Default: 58 minutes
NOTE:
WisDom: Engineer menu: 1) System > 1) Timers > 9) Accessory
supervision time
Agility: Engineer menu: 1) System > 1) Timers > TX supervision
LightSYS (V2.40 and above): Engineer menu: 1) System > 1)
Timers > 6) Wireless > 3) TX supervision
Wireless Sounder Instructions 6