Energizer EZG Serie Manual De Instrucciones página 112

EN
1) Unsnap the air cleaner cover clips, remove the air cleaner cover, and remove the element.
2) Wash the element in a solution of household detergent and warm water, then rinse thoroughly; or wash in
nonflammable or high flash point solvent. Allow the element to dry thoroughly
3) Soak the element in clean engine oil and squeeze out the excess oil. The engine will smoke during initial start-
up it too much oil is left in the element.
4) Reinstall the air cleaner element and the cover.
5) Fuel Sediment Cup Cleaning
The sediment cup prevents dirt or water which may be in the fuel tank
from entering the carburetor. If the engine has not been run for a long
time, the sediment cup should be cleaned.
1) Turn the fuel valve to the OFF position. Remove the sediment cup,
and O-ring.
2) Clean the sediment cup, and O-ring, in nonflammable or high flash
point solvent.
3) Reinstall O-ring, and sediment cup.
4) Turn the fuel valve ON and check for leaks.
6) Spark Plug Service
Recommended spark plugs: F5T or F6TC or F7TJC or other equivalents
To ensure proper engine operation, the spark plug must be properly gapped and free of deposits.
If the engine has been running, the muffler will be very hot. Be careful not to touch the muffler.
1) Remove the spark plug cap.
2) Clean any dirt from around the spark plug base.
3) Use the wrench supplied in the tool kit to remove the spark plug.