Saber R33CC0312 Instrucciones De Montaje página 6

Procedure - Removing the Existing Control Panel
Remove your new Control Panel from the shipping carton, being careful not to damage the carton. This
•
8
carton will be used to re-pack the old Control Panel for shipment back to Saber Grills.
Place your old Control Panel into the carton, seal it up with packing tape and place the prepaid, return shipping label
•
on it in a conspicuous location.
Please drop the package off at the nearest shipping facility as soon as possible; or call the toll free number on the
•
label to schedule a pick-up.
Procedure - Installing the new Control Panel
In this step you will prepare the new Control
9
Panel for installation, re-connect the Ignitor
Wires and Light Switch Wires to their Switches.
NOTE - Be sure to wear your gloves for this step.
•
On the right hand Side, first bend up the flap on the
•
Heat Shield in the same manner that you did on the
old Control Panel.
Route the Regulator and Hose through the opening
•
and be sure it is behind the Door Braces and Doors.
Route the Side Burner Hose through the Side Panel,
•
if equipped with a Side Burner.
Next, place the Control Panel on the top of the
•
Doors in the same manner as when you removed
the old one. Be sure to support it so it doesn't fall.
10
Starting on the left hand Side, press each Wire
•
Terminal onto one of the Switch Spades. Either Wire
can go on either Spade.
Next, on the right hand side, press the red Wire
•
terminal onto the center Switch Spade shown at
right.
Press the black Wire onto the Switch shown at
•
right.
Refer to step 7 for proper Wire placement.
•
Check that the Wires are securely placed and then
•
bend the Heat Shield flap back down as it was
originally.
© Saber Grills, LLC
All manuals and user guides at all-guides.com
Right Hand
Side
6
Rotate the Control
Panel and allow it to
rest on the top of the
Doors.
Left Hand
Side
Red Wire
Not Used
Heat Shield is
shown transparent
80028080 ● 09/13/17 ● Revision 03
Printed in U.S.A.
Tabs
Black Wire
sabergrills.com