Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Initial Operation
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On and Off
To start the machine, press the On/Off switch 3
forward and then down.
To lock-on, push the pressed On/Off switch 3
further forwards.
To switch off the machine, release the On/Off
switch 3 or push and release it then.
Switch version without lock
(country-specific):
To start the machine, press the On/Off switch 3
forward and then down.
To switch off the machine, release the On/Off
switch 3.
Test run!
Check the grinding tool before use. The grind-
ing tool must be properly mounted and rotate
freely. Perform a test run of at least
30 seconds without load. Do not use dam-
aged, out-of-round or vibrating grinding tools.
Run-on Brake (BTI-WKS 230 SE)
This machine is equipped with the
BTI Brake System.
When switching off or in case of a power supply
interruption, the grinding tool is stopped within a
few seconds. This means the run-on time is re-
duced by approx. 70 % in comparison to angle
grinders without run-on brake, and that the ma-
chine can be placed down in shorter time.
Should the braking effect of the run-on brake no-
ticeably diminish, have the machine checked by
an after-sales service centre for BTI power tools.
Reduced Starting Current
As a result of soft starting, a 13 A fuse is ade-
quate.
All manuals and user guides at all-guides.com
Rough Grinding
Flap Disc
With the flap disc (accessory), curved surfaces
and profiles (contour sanding) can be worked.
Flap discs have a considerably higher service life
than sanding sheets, lower noise level and lower
sanding temperatures.
Cutting
Do not reduce the speed of running down cutting
discs by applying sideward pressure.
English - 5
Operating Instructions
Clamp the workpiece if it does not remain
stationary due to its own weight.
Do not strain the machine so heavily that it
comes to a standstill.
Grinding and cutting discs become very
hot while working; do not touch until they
have cooled.
The best roughing results are
achieved when setting the machine
at an angle of 30° to 40°. Move the
machine back and forth with mod-
erate pressure. In this manner, the
workpiece will not become too hot,
does not discolour and no grooves
are formed.
Never use a cutting disc for roughing.
When cutting, do not press, jam or
oscillate the machine. Work with
moderate feed, adapted to the ma-
terial being machined.
The direction in which
the cutting is per-
formed is important.
The machine must
always work in an
up-grinding
motion.
Therefore,
never
move the machine in
the other direction!
Otherwise, the dan-
ger exists of it being
pushed
uncon-
trolled out of the cut.
Tabla de contenido
