HoMedics MyChill Guia De Inicio Rapido

READ AND SAVE THESE INSTRUCTIONS
CAUTION: Before filling the unit with water, unplug the Power Adapter from the wall and from the unit.
NOTE: Always hold the personal space cooler firmly by the bottom of the unit with both hands when carrying.
PERSONAL SPACE COOLER LOCATION
Place the Personal Space Cooler in the desired location prior to filling with water. The front of the unit should
be located within 4-FT of the desired personal cooling zone. We recommend placing a waterproof pad under
the unit.
1. Be sure the Cooling Media is
positioned with the "V-shaped"
vents facing upward. Never operate
the unit without the cooling media.
5. Place the tank into the MyChill
cavity, making sure the tank is
firmly seated. Water will begin to
transfer into the water reservoir.
POWER
Plug the Power Adapter into the back of the unit and the other end into a 120 volt AC electrical outlet.
Press the POWER button to turn the unit ON.
All manuals and user guides at all-guides.com
Quick Start Guide
2. Remove the water tank and turn the
tank upside down – remove the tank
cap by turning it counter-clockwise.
6. Once the water stops emptying into the
water reservoir, remove the water tank
and refill following steps 2-5 to fully
fill the water tank and reservoir.
3. Fill the water tank with clean, cool
(not cold) water. We recommend
using distilled water if you live in
a hard water area. Never use any
additive or place essential oils into
the water. Even a few drops will
damage the unit.
7. Adjust the front vents up or down to
direct the airflow as desired.
4. Replace the tank cap by turning
clockwise until tight. Do not
overtighten.
8. Your personal space cooler is
ready for use.
QS-PAC20