Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Reference regulation
The transmitter has an EC type approval certification and in particular is compliant with EN 300 220-2, EN
301 489-1 and EN 301 489-3 European Standards. The product has been tested in compliance with EN
60065 standards.
If are used antennas with a gain higher than 0 dB, the user is required to observe EIRP limits specified in
regulations in force in that country (in Italy, 10 dBm), using the trimmer and/or adding an attenuator with a
nominal value lower or equivalent to the antenna gain.
If it is not possible to measure the antenna output power (EIRP) and are not used attenuators, it will be
possible to use, on the Ref. 1094/001T transmitter only, the Ref. 1094/051 stylus antenna only.
Note
•
However, it is needed to pay attention to the execution of the physical connection.
•
For an optimal performance, the antenna must be carefully oriented, as described below. To
obtain the maximum radio coverage, it is necessary to reduce to a minimum the obstacles (for
example other electronic devices, metal structures, large-sized furniture) in the area between the
transmitter and the receiver.
Ref. 1094/001T
Common problems resolution
PROBLEM
Absence of video and audio
Presence of interferences or
noise on video or audio
14
All manuals and user guides at all-guides.com
Check that the two antennas are
oriented in the same direction
Fig.1: Antennas optimal orientation
Check that all the cables are correctly connected.
Make sure that all the power supply sockets are plugged.
Check the correct presence of video sources.
Change receiver and transmitter antennas orientation.
Select a different communication channel (both on transmitter
and receiver)
If several devices are used at the same time, select
communications on different channels.
If a microwave oven is used, try to turn it off.
Ref. 1094/001R
POSSIBLE SOLUTIONS
DS1094-000
Tabla de contenido
