Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Rear panel or Ref. 1094/001T and Ref.1094/001R devices
ID
1
2
3
INSTALLATION
1.
Before starting installing procedures, make sure all the devices to be connected are not powered and
all the buttons are in OFF position.
2.
The transmitter and the receiver must be located on a level and steady surface, to avoid damages.
3.
Connect the transmitter to the camera with the RCA-RCA cable, using the RCA/BNC adapter, if
necessary.
4.
Connect the receiver to the monitor with the RCA-RCA cable, using the RCA/BNC adapter, if
necessary.
5.
Select the same channel for receiver and transmitter.
6.
Adjust the transmitter gain to minimum value (ID no. 5 of table 2).
7.
Make the necessary connections on the receiver and on the transmitter.
8.
Power the devices.
9.
Check if the red power supply led "1" turns on on receiver and transmitter.
10.
Check the presence of audio/video signal on the monitor.
11.
If it is not possible to obtain clear images, orient the antennas in order to stabilize the signal.
12.
If it not possible to obtain clear images yet, increase the transmitter gain.
13.
If the noise still persists, go back to step 5 and change channel.
Note
In order to keep parameters compliant with regulations in force (see paragraph "Reference regulation"), it is
suggested to check that the antenna output power (EIRP) is not higher than 10dBm, and follow all the
recommendations detailed in paragraph "Installation".
URMET S.p.A disclaims all responsibility if are not followed all the previously mentioned recommendations.
DS1094-000
All manuals and user guides at all-guides.com
1
DESCRIPTION
Power supply connector
Audio connector
Video connector
Table 3
2
3
13
Tabla de contenido
